Mitutoyo SURFTEST SJ-410 - Page 34

No. 99MBB765A
2-2
■ Functions of Keys
•
Used to print. Printing starts when this key is pressed. Printing stops when
[STOP] key is pressed during printing.
TIP
• For information about printing, refer to "4.7 Print the Measurement Results" (page 4-21).
•
Used to feed the paper on the printer.
• Used to output data to the Digimatic data processor using SPC or save data to
SD cards. By setting the Output key roles, SPC data can be output or measurement
results and screen image can be saved to an SD card.
・ SPC data output
A Digimatic Processor must be connected to the SJ-410 in advance.
To output data with SPC, move the SPC mark to the parameter to output, and
then, press this key.
・ Saving measurement results to SD card
An SD card must be inserted to the SJ-410 in advance.
To save data to an SD card, press this key.
・ Saving screen image to SD card
An SD card must be inserted to the SJ-410 in advance.
To save screen image to an SD card, press this key.
TIP
• For information about data output with SPC, refer to "18.1 SPC Data Output" (page
18-3).
• For information about setting SPC data output, refer to "13.4.1 Setting the data output to
SPC" (page 13-7).
• For information about saving data to an SD card, refer to "18.2 Saving Data to the SD
Card" (page 18-6).
• For information about saving screen image to an SD card, refer to "13.4.3 Setting the
data output to hard copy" (page 13-9).
• Used to display the Menu screen.
•
Used to stop measurement or printing.
•
Used to start measurement.