16. DISPLAYING AND ANALYZING THE EVALUATION PROFILES AND GRAPHS
No. 99MBB765A
TIP
• The slice level is displayed in blue, and the peak height level is displayed in red.
• When initially displaying the Analyze Convex Step screen after measurement, the
ruler is displayed on the mean line.
• To perform the convex step analysis using the Evaluating Conditions B, select the
evaluation profile by touching
[Switch Profile] on the Analyze Step Size screen.
• In case of entering the numerical values on the Analyze Step Size screen, program
the settings so that slice level ≦ peak height level.
■ Specifying by touching the evaluation profile (Refer to 16.1 "■ Accessing the Analyze Waveform screen".)
Home screen ⇒ [Evaluation Profile] ⇒ [Analyze Waveform]
Analyze Waveform screen
Touch .
NOTE
• When R-Motif or W-Motif is selected for a profile motif,
the step size cannot be analyzed.
Analyze Step Size screen
Touch
[Concave Step]
.
Analyze Step Size screen
The rulers are displayed on the Analyze Step Size screen.
The blue one is Ruler 1, the red one is Ruler 2.
When the Z-coordinate is specified for the first time, ruler 1 is
selected.
(blue) is displayed on the selected ruler.
To Next Page
Loading...
