Mitutoyo SURFTEST SJ-410 - Page 448

No. 99MBB765A
16-46
Analyze BAC Graph screen
 The rulers are displayed on the Analyze BAC Graph screen.
The blue line is ruler P1 and the red line is ruler P2.
When the Z-coordinate is specified for the first time, ruler P2 is
selected.
(blue) is displayed on the left of the selected ruler.
2
Touch [Enter Value].
BAC Coordinate Value Entry screen
3
Enter the start point position (ruler P1 position).
TIP
• For information ab
out numeric value entry, refer to
"2.2.4 Entering numeric values/characters" (page 2-5).
Analyze BAC Graph screen
4
Touch [Switch Ruler].
 Ruler P2 is selected and
(red) is displayed on the left of the
ruler.
5
Touch
[Enter Value].
BAC Coordinate Value Entry screen
6
Enter the end point position (ruler P2 position).
TIP
•
For information about numeric value entry, refer to
"2.2.4 Entering numeric values/characters" (page 2-5).