16. DISPLAYING AND ANALYZING THE EVALUATION PROFILES AND GRAPHS
No. 99MBB765A
■ Specifying the Z-coordinate by entering the values (Refer to 16.1 "■ Accessing the Analyze Graph screen".)
Home screen ⇒ [Graph] ⇒ [Analyze Graph]
Analyze Waveform screen
Touch .
Analyze ADC Graph screen
The ruler is displayed on the Analyze ADC Graph screen.
Touch
[Enter Value].
ADC Coordinate Value Entry screen
Input the Z-coordinate.
TIP
•
For information about numeric value entry, refer to
"2.2.4 Entering numeric values/characters" (page 2-5).
Analyze ADC Graph screen
The X-coordinate against the set Z-coordinate is displayed on
the Analyze ADC Graph screen.
NOTE
•
When the unit of the Z-axis is set to length, the
coordinate pointed by the ruler indicates the ADC
calculation data near the input values. Therefore, the
input value does not always match the Z-axis value
pointed by the ruler.
TIP
• When is pressed on this screen, the ADC graph
with the ruler displayed and the coordinate value
pointed by the ruler are printed.
To Next Page
Loading...
