No. 99MBB765A
9 Place a new battery pack inside the display unit.
IMPORTANT
• Exercise care not to have the cable or ferrite core pinched when attaching the built-in
battery cover to the display unit. Cable or display unit breakage may result.
10 Attach the built-in battery cover to the display unit.
NOTE
• The screws must not be tightened to more than 29.4 N･cm (3 kgf･cm). Otherwise, the
display unit may be damaged.
11 Tighten the three screws at the bottom of the display unit.
12 Set the built-in battery switch at the rear of the display unit to ON.
NOTE
• At the point of purchase, the built-
in battery is not fully charged. Before using the
SJ-410, recharge the built-
in battery. It takes about maximum of 4 hours to fully
recharge it.
To Next Page
Loading...
