Mitutoyo SURFTEST SJ-410 - Page 500

No. 99MBB765A
21-4
Symptom/Error
display
Possible causes
Remedies
Printing-out can not be
performed even by
pressing .
is pressed on the screen where
printing-out is not available.
All the print items are set to OFF.
Set the print items.
For information about printing for normal
measurement, refer to "13.5 Print Setup" (page
13-10).
For information about printing for statistical
measurement, refer to "12.6 Printing the Statistical
Results" (page 12-9).
No evaluation data
Print the data after measurement.
Printer anomaly
Restart the SJ-410, then confirm that printing-out can
be performed normally.
If the SJ-410 does not recover from the error, contact
your dealer or the nearest Mitutoyo sales office.
Stylus has been changed.
This message appears to alert you that the stylus
used may differ from the preset stylus.
Confirm that the stylus used is the same as the
preset stylus.