Mitutoyo SURFTEST SJ-410 - Page 505

21. TROUBLESHOOTING
No. 99MBB765A
21-9
Symptom/Error
display
Possible causes
Remedies
Inaccessible to
theSD card.
Others
After formatting the SD card by PC, format it for the SJ-410.
IMPORTANT
• When the SD card is formatted by PC, note that
all of its contents are erased.
• No warranty is given in regrads to operation
using all the cards.
0
Message "Number
of files over." is
displayed while the
measurement
results are being
saved.
The number of files
exceeded the maximum
number of files to be
saved in each folder (500
files).
Change the folder to save the files to the one with a free space.
Refer to "10.4.3 Specifying the main folder" (page 10-12).
After deleting unnecessary data, save the data again.
Refer to "10.5 Deleting the Measurement Results from the SD Card" (page 10-13).
Message "Number
of files over." is
displayed while
saving the
measurement
conditions, statistical
data, and hard
copies of the screen.
The number of files
including the
measurement conditions,
statistical data, and hard
copies of the screen
exceeded 500 files.
After deleting unnecessary data, save the data again.
Refer to "10.5 Deleting the Measurement Results from the SD Card" (page 10-13).
Use a new SD card.
Message "Over FIle
Capacity" is
displayed while the
data are being
saved.
Capacity of the card has
been exceeded.
After deleting unnecessary data, save the data again.
Refer to "10.5 Deleting the Measurement Results from the SD Card" (page 10-13).
Use a new SD card.
RS-232C Out of
communication.
Communication baud rate
does not match the PC.
Set the communication baud rate to the same numeric value as that of the PC.
Refer to "13.14 Setting PC Communication Conditions" (page 13-43).