*1: Optional parts for which use with the simple column stand is recommended.
*2: 70-mm height stage to be installed onto the base This stage is necessary for
calibration with the precision roughness specimen when the simple column stand
(178-039) is mounted as the terminal position of the stylus is 40 mm from the base upper
surface. However, this is not necessary when the table, such as cross-travel table,
leveling table, or XYZ adjustment table, is used.
*3: Install this onto the cross-travel table, leveling table, or XYZ adjustment table for use.
*4: This is a standard accessory of the XYZ adjustment table.
*5: This is necessary for using the Digimatic Mini Processor and input tool.
*6: Depends on the shipping destination.
To Next Page
Loading...
