• Avoid using the instrument where there is sudden temperature change, and operate it
where the temperature is between 5 and 40 °C (RH: 85 % or less, free from dew
condensation). Do not operate/store the instrument close to a room heater or in the
direct sunlight.
• Store the instrument where the temperature can be controlled between -10 and 50 °C.
• When mounting the detector to the drive unit, take care not to apply excessive force to
the drive unit.
• Before connecting/detaching the connector or connecting cable, turn the power off (by
auto sleep function).
• The stylus tip is machined precisely. Take care not to break it.
• Before measurement, wipe off oil or dust on the work piece surface to be measured. For
supplying power to this system prepare an outlet rated to AC100V-240V ± 10%, 50/60
Hz. The supplied power should have a sufficient margin over the system consumption
rate.
• Do not place an object on the touch panel or give impact to the touch panel. Otherwise,
the touch panel may be damaged.
• Do not press the touch panel with a sharp-pointed object (such as a pen). Otherwise,
the touch panel may be damaged. To operate by the touch panel, use your finger or the
supplied touch pen.
To Next Page
Loading...
