Jitter analysis and clock data recovery
R&S
®
RTP
1034User Manual 1337.9952.02 ─ 12
1 = Periodic jitter spectrum
2 = Periodic components results
3 = Analyzed signal spectrum
4 = Periodic noise spectrum
Figure 18-7: Advanced jitter and noise periodic results display
1 = Periodic components results
2 = Analyzed signal spectrum
4 = Periodic jitter spectrum
3 = Periodic noise spectrum
18.2.5.1 General settings
In the "General Settings" section of the "Results" dialog, you can enable the advanced
jitter analysis, and select which results you want to display.
Enable
Enables the advanced jitter analysis. It displays all enabled diagrams and displays a
table with the results for the component measurements. It also displays the measure-
ment results for all enabled Basic components , Jitter Components.
Remote command:
ADVJitter<m>:RESult:ENABle on page 2271
Advanced jitter and noise (option R&S
RTP- K133/K134)
To Next Page
Loading...
