Jitter analysis and clock data recovery
R&S
®
RTP
1037User Manual 1337.9952.02 ─ 12
●
For jitter measurements, you can select between absolute (seconds) and relative
(unit intervals) values.
●
For noise measurements, you can select between absolute (V) and relative (%)
values.
Remote command:
ADVJitter<m>:RESult:UNIT on page 2273
18.2.5.2 Basic measurement settings
Access: "Analysis" menu > "Advanced Jitter" > "Result" tab > "Basic".
In the "Basic" tab, you can add measurements for better understanding of the collected
data. You can then enable a histogram or track on them, see Component specific
results.
Add / remove components
Opens a dialog to select the jitter and noise components.
Basic components
To display the measurement results, "Enable" the advanced jitter analysis in the
"Results" tab.
Advanced jitter and noise (option R&S
RTP- K133/K134)
To Next Page
Loading...
