Rohde & Schwarz RTP Series - Page 1168

Remote control commands
R&S
®
RTP
1168User Manual 1337.9952.02 ─ 12
Usage: Asynchronous command
Firmware/software: FW 3.20
LAYout:ZOOM:ONEDiagram <ShowInOne>
Shows all zooms of a diagram in one zoom window. The zoomed areas are overlaid for
better comparison of the zoomed waveforms.
The command takes effect on all zoom diagrams.
Parameters:
<ShowInOne> ON | OFF
*RST: OFF
Usage: Asynchronous command
22.7.2.6
Annotation
DISPlay:SIGNal:LABel:POSMode.................................................................................. 1168
DISPlay:SIGNal:LABel:FONTsize...................................................................................1169
DISPlay:SIGNal:LABel:ADD.......................................................................................... 1169
DISPlay:SIGNal:LABel:REMove.....................................................................................1171
DISPlay:SIGNal:LABel:SHOW.......................................................................................1171
DISPlay:SIGNal:LABel:TEXT.........................................................................................1172
DISPlay:SIGNal:LABel:HORizontal:ABSolute:POSition.................................................... 1173
DISPlay:SIGNal:LABel:VERTical:ABSolute:POSition........................................................1173
DISPlay:SIGNal:LABel:HORizontal:RELative:POSition.....................................................1173
DISPlay:SIGNal:LABel:VERTical:RELative:POSition........................................................1173
DISPlay:SIGNal:LABel:POSMode <Source>, <PositionMode>
DISPlay:SIGNal:LABel:POSMode? <Source>
Modifies or queries the position mode: either relative to the diagram or with absolute
values according to the units of the waveform. The position mode applies to all labels
of the selected source. For different sources, different position modes can be selected.
Parameters:
<PositionMode> ABS | REL
ABS
Position in time and voltage values, or in other units depending
on the waveform character. Absolute positions move with the
waveform display when the scales, the vertical position or offset,
or the reference point are changed.
Use DISPlay:SIGNal:LABel:HORizontal:ABSolute:
POSition and DISPlay:SIGNal:LABel:HORizontal:
RELative:POSition to set the position.
Instrument setup