Rohde & Schwarz RTP Series - Page 1169

Remote control commands
R&S
®
RTP
1169User Manual 1337.9952.02 ─ 12
REL
Fixed label position in percent of the screen counting from the
upper left corner.
Use DISPlay:SIGNal:LABel:HORizontal:RELative:
POSition and DISPlay:SIGNal:LABel:VERTical:
RELative:POSition to set the position.
Parameters for setting and query:
<Source> All waveforms that can be displayed, see DISPlay:SIGNal:
LABel:ADD
Usage: Asynchronous command
DISPlay:SIGNal:LABel:FONTsize <Fontsize>
Sets the font size of waveform labels.
Parameters:
<Fontsize> Range: 7 to 30
Increment: 1
*RST: 15
Usage: Asynchronous command
DISPlay:SIGNal:LABel:ADD <LabelID>, <Source>, <LabelText>, <PositionMode>,
<XPositon>, <YPositon>
Creates a new waveform label for the specified source waveform.
Setting parameters:
<LabelID> String with the label identifier. The <LabelID> and <Source>
parameters identify each label uniquely, so the label ID must be
unique for the given waveform. Note the <LabelID> because it is
not possible to query it, or to read it on the user interface.
Instrument setup