Rohde & Schwarz RTP Series - Page 1221

Remote control commands
R&S
®
RTP
1221User Manual 1337.9952.02 ─ 12
Return values:
<VoltageMeas> Common mode voltage
Range: -100E+24 to 100E+24
Increment: 1E-3
*RST: 0
Default unit: V
Usage: Query only
Asynchronous command
PROBe<m>:SETup:TERM:ADJust <VoltageAdjust>
Sets the voltage to be used for termination correction.
Suffix:
<m>
.
1..4
Parameters:
<VoltageAdjust> Correction voltage
Range: -100E+24 to 100E+24
Increment: 1E-3
*RST: 0
Default unit: V
Usage: Asynchronous command
22.8.7.6 Modular probes, deembedding
The commands of this chapter are relevant for R&S RT-ZM modular probes when used
for measurements on signal frequencies of 4 GHz and higher. The commands are
available in firmware version 4.00 and higher.
See also: PROBe<m>:SETup:PRMode on page 1218
PROBe<m>:DEEMbedding:PMODe...............................................................................1221
PROBe<m>:DEEMbedding:TIPModule[:SELect]............................................................. 1222
PROBe<m>:DEEMbedding:TIPModule:CSPFile..............................................................1222
PROBe<m>:DEEMbedding:TIPModule:ZMA<n>:SUBModule...........................................1222
PROBe<m>:DEEMbedding:BANDwidth..........................................................................1223
PROBe<m>:DEEMbedding:MODE................................................................................ 1223
PROBe<m>:DEEMbedding:REMProbeload.................................................................... 1224
PROBe<m>:DEEMbedding:LOAD:IMPedance?.............................................................. 1224
PROBe<m>:DEEMbedding:PMODe <MeasMode>
Suffix:
<m>
.
1..4
Acquisition and setup