Rohde & Schwarz RTP Series - Page 1282

Remote control commands
R&S
®
RTP
1282User Manual 1337.9952.02 ─ 12
Usage: Asynchronous command
22.9.13.2 Single/dual bit pattern
TRIGger<m>:SERPattern:BITPattern:APATtern.............................................................. 1282
TRIGger<m>:SERPattern:BITPattern:BPATtern.............................................................. 1282
TRIGger<m>:SERPattern:BITPattern:PTALength............................................................ 1282
TRIGger<m>:SERPattern:BITPattern:PTBLength............................................................1283
TRIGger<m>:SERPattern:BITPattern:APATtern <BPatternA>
Defines the bit pattern/ bit pattern A, if TRIGger<m>:SERPattern:PTMDe is set to
SBP or DBP.
Suffix:
<m>
.
1..3
Parameters:
<BPatternA> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
Usage: Asynchronous command
TRIGger<m>:SERPattern:BITPattern:BPATtern <BPatternB>
Defines the bit pattern B, if TRIGger<m>:SERPattern:PTMDe is set to DBP.
Suffix:
<m>
.
1..3
Parameters:
<BPatternB> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
Usage: Asynchronous command
TRIGger<m>:SERPattern:BITPattern:PTALength <PatternALen>
Sets the length of the bit pattern A.
Suffix:
<m>
.
1..3
Parameters:
<PatternALen> Range: 1 to 160
Increment: 1
*RST: 8
Trigger