Rohde & Schwarz RTP Series - Page 1283

Remote control commands
R&S
®
RTP
1283User Manual 1337.9952.02 ─ 12
TRIGger<m>:SERPattern:BITPattern:PTBLength <PatternBLen>
Sets the length of the bit pattern B.
Suffix:
<m>
.
1..3
Parameters:
<PatternBLen> Range: 1 to 160
Increment: 1
*RST: 8
Usage: Asynchronous command
22.9.13.3
Complex word pattern
TRIGger<m>:SERPattern:COMPlex:BORDer................................................................. 1283
TRIGger<m>:SERPattern:COMPlex:CLOGic.................................................................. 1283
TRIGger<m>:SERPattern:COMPlex:IDLRange............................................................... 1284
TRIGger<m>:SERPattern:COMPlex:SOFState............................................................... 1284
TRIGger<m>:SERPattern:COMPlex:SOFTimeout........................................................... 1284
TRIGger<m>:SERPattern:COMPlex:SOFLength............................................................. 1285
TRIGger<m>:SERPattern:COMPlex:SOFPattern.............................................................1285
TRIGger<m>:SERPattern:COMPlex:PATTern<n>:BOFFset.............................................. 1285
TRIGger<m>:SERPattern:COMPlex:PATTern<n>:ENABle................................................1285
TRIGger<m>:SERPattern:COMPlex:PATTern<n>:FRPTtern.............................................1286
TRIGger<m>:SERPattern:COMPlex:PATTern<n>:PATLength........................................... 1286
TRIGger<m>:SERPattern:COMPlex:PATTern<n>:PCONdition..........................................1286
TRIGger<m>:SERPattern:COMPlex:PATTern<n>:SRNGe................................................1287
TRIGger<m>:SERPattern:COMPlex:PATTern<n>:TOPTtern.............................................1287
TRIGger<m>:SERPattern:COMPlex:BORDer <BitOrder>
Sets the most significant bit (MSB) or least significant bit (LSB) to define the data bit
order.
Suffix:
<m>
.
1..3
Parameters:
<BitOrder> LSB | MSB
*RST: MSB
Usage: Asynchronous command
TRIGger<m>:SERPattern:COMPlex:CLOGic <CondLogic>
Selects the logic for the condition, if more than one pattern conditions are defined.
Trigger