Rohde & Schwarz RTP Series - Page 1285

Remote control commands
R&S
®
RTP
1285User Manual 1337.9952.02 ─ 12
Parameters:
<SOFTimeout> Range: 40E-9 to 150
Increment: 10E-6
*RST: 5E-6
Default unit: s
TRIGger<m>:SERPattern:COMPlex:SOFLength <SOFPatternLen>
Sets the length of the pattern for the trigger alignment condition.
Suffix:
<m>
.
1..3
Parameters:
<SOFPatternLen> Range: 1 to 132
Increment: 1
*RST: 8
Usage: Asynchronous command
TRIGger<m>:SERPattern:COMPlex:SOFPattern <SOFPattern>
Sets the bit pattern value for the trigger alignment condition, if TRIGger<m>:
SERPattern:COMPlex:SOFState is set to PATTern.
Suffix:
<m>
.
1..3
Parameters:
<SOFPattern>
Usage: Asynchronous command
TRIGger<m>:SERPattern:COMPlex:PATTern<n>:BOFFset <BitOffset>
Sets the number of arbitrary bits between the first bit after the frame id and the first bit
of the word pattern.
Suffix:
<m>
.
1..3
<n> 1..4
Selects the complex pattern condition.
Parameters:
<BitOffset> Range: 0 to 255
Increment: 1
*RST: 0
TRIGger<m>:SERPattern:COMPlex:PATTern<n>:ENABle <Enable>
Enables a new pattern condition.
Trigger