Rohde & Schwarz RTP Series - Page 1557

Remote control commands
R&S
®
RTP
1557User Manual 1337.9952.02 ─ 12
TRIGger<m>:I2C:AMODe.............................................................................................1558
TRIGger<m>:I2C:ACONdition....................................................................................... 1559
TRIGger<m>:I2C:ADDRess.......................................................................................... 1559
TRIGger<m>:I2C:ADDTo.............................................................................................. 1559
TRIGger<m>:I2C:ADOR<n>:ENABle............................................................................. 1559
TRIGger<m>:I2C:ADOR<n>:ADRType...........................................................................1560
TRIGger<m>:I2C:ADOR<n>[:VALue]............................................................................. 1560
TRIGger<m>:I2C:ADOR<n>:RWBit................................................................................1560
TRIGger<m>:I2C:DPOPerator.......................................................................................1561
TRIGger<m>:I2C:DPOSition......................................................................................... 1561
TRIGger<m>:I2C:DPTO................................................................................................1561
TRIGger<m>:I2C:DCONdition....................................................................................... 1561
TRIGger<m>:I2C:DMIN................................................................................................ 1562
TRIGger<m>:I2C:DMAX............................................................................................... 1562
TRIGger<m>:I2C:MODE <Type>
Selects the trigger type for I²C analysis.
See: "Trigger type" on page 526.
Parameters:
<Type> STARt | REPStart | STOP | NACK | ADDRess | ADOR | ADAT
STARt
Start condition
REPStart
Repeated start - the start condition occurs without previous stop
condition.
STOP
Stop condition, end of frame
NACK
Missing acknowledge bit. To localize specific missing acknowl-
edge bits, use TRIGger<m>:I2C:ADNack, TRIGger<m>:
I2C:DWNack, and TRIGger<m>:I2C:DRNack.
ADDRess
Triggers on one specific address
ADOR
Triggers on an OR combination with up to four four address con-
ditions.
ADAT
Triggers on a combination of address and data condition.
*RST:
STARt
Usage: Asynchronous command
TRIGger<m>:I2C:ACCess <RWBitAddress>
Sets the trigger condition for the R/W bit - the transfer direction of the data.
Protocols