Rohde & Schwarz RTP Series - Page 1652

Remote control commands
R&S
®
RTP
1652User Manual 1337.9952.02 ─ 12
Return values:
<FrameType> DATA | REMote | ERR | OVLD
*RST: DATA
Usage: Query only
22.17.6.6 Symbolic trigger, decode and search
● Symbolic trigger.................................................................................................. 1652
● Symbolic decode results..................................................................................... 1653
● Symbolic search..................................................................................................1654
Symbolic trigger
TRIGger<m>:CAN:SYMBolic:MSGValue........................................................................ 1652
TRIGger<m>:CAN:SYMBolic:TSIGnals.......................................................................... 1652
TRIGger<m>:CAN:SYMBolic:SIGValue.......................................................................... 1652
TRIGger<m>:CAN:SYMBolic:DMAX.............................................................................. 1653
TRIGger<m>:CAN:SYMBolic:DMIN............................................................................... 1653
TRIGger<m>:CAN:SYMBolic:SGEValue.........................................................................1653
TRIGger<m>:CAN:SYMBolic:MSGValue <MessageName>
Sets the message to be triggered or searched for.
The setting is used by symbolic trigger and symbolic search. Thus, you always trigger
on and search for the same message if symbolic trigger and symbolic search is used at
the same time.
See also: SEARch:TRIGger:CAN:SYMBolic:MSGValue on page 1655
Parameters:
<MessageName> String with the symbolic message name
TRIGger<m>:CAN:SYMBolic:TSIGnals <TriggerOnSignal>
Enables the trigger on a specific signal value that is part of the selected message.
Parameters:
<TriggerOnSignal> ON | OFF
*RST: OFF
TRIGger<m>:CAN:SYMBolic:SIGValue <SignalName>
Sets the signal name to be triggered or searched for.
The setting is used by symbolic trigger and symbolic search. Thus, you always trigger
on and search for the same signal if symbolic trigger and symbolic search is used at
the same time.
See also: SEARch:TRIGger:CAN:SYMBolic:SIGValue on page 1655
Protocols