EasyManua.ls Logo

Rohde & Schwarz RTP Series - Page 1733

Rohde & Schwarz RTP Series
2403 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remote control commands
R&S
®
RTP
1733User Manual 1337.9952.02 ─ 12
INRange | OORange
In range, Out of range. Set the minimum and maximum value of
the range with TRIGger<m>:ETHernet:FRAMe:DMIN and
TRIGger<m>:ETHernet:FRAMe:DMAX.
*RST: EQUal
TRIGger<m>:ETHernet:FRAMe:DMAX <DestAddrPattMax>
Sets the end value of a destination address range, if TRIGger<m>:ETHernet:
FRAMe:DMAX is set to INRange or OORange.
Suffix:
<m>
.
1..3
Parameters:
<DestAddrPattMax>
TRIGger<m>:ETHernet:FRAMe:DMIN <DestAddrPattMin>
Specifies a destination address pattern, or sets the start value of a pattern range.
Suffix:
<m>
.
1..3
Parameters:
<DestAddrPattMin>
TRIGger<m>:ETHernet:FRAMe:SCONdition <SrcAddrOperator>
Sets source address operator to trigger on a specific pattern or a range.
Suffix:
<m>
.
1..3
Parameters:
<SrcAddrOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less than or equal, Greater Than,
Greater than or equal. These conditions require a destination
address to be set with TRIGger<m>:ETHernet:FRAMe:SMIN.
INRange | OORange
In range, Out of range. Set the minimum and maximum value of
the range with TRIGger<m>:ETHernet:FRAMe:SMIN and
TRIGger<m>:ETHernet:FRAMe:SMAX.
*RST: EQUal
TRIGger<m>:ETHernet:FRAMe:SMAX <SrcAddrPattMax>
Sets the end value of a range, if the data condition is set to INRange or OORange.
Protocols

Table of Contents

Other manuals for Rohde & Schwarz RTP Series

Related product manuals