Rohde & Schwarz RTP Series - Page 1741

Remote control commands
R&S
®
RTP
1741User Manual 1337.9952.02 ─ 12
SEARch:TRIGger:ETHernet:ERRor:SELect....................................................................1745
SEARch:TRIGger:ETHernet:ERRor:PREamble...............................................................1745
SEARch:TRIGger:ETHernet:ERRor:LENGth...................................................................1745
SEARch:TRIGger:ETHernet:FRAMe:SELect <SearchName>,<CheckFrame>
SEARch:TRIGger:ETHernet:FRAMe:SELect? <SearchName>
Defines, whether a search within a frame shall be activated or not.
Parameters:
<CheckFrame> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName> String parameter
SEARch:TRIGger:ETHernet:FRAMe:DCONdition
<SearchName>,<DestAddrOptor>
SEARch:TRIGger:ETHernet:FRAMe:DCONdition? <SearchName>
Defines the operator to search a specific destination address within a frame.
Parameters:
<DestAddrOptor> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less than or equal, Greater Than,
Greater than or equal. These conditions require a destination
address to be set with SEARch:TRIGger:ETHernet:FRAMe:
DMIN.
INRange | OORange
In range, Out of range. Set the minimum and maximum value of
the range with SEARch:TRIGger:ETHernet:FRAMe:DMIN
and SEARch:TRIGger:ETHernet:FRAMe:DMAX.
*RST:
EQUal
Parameters for setting and query:
<SearchName> String parameter
SEARch:TRIGger:ETHernet:FRAMe:DMIN <SearchName>,<DestAddrPattMin>
SEARch:TRIGger:ETHernet:FRAMe:DMIN? <SearchName>
Defines a destination address, or sets the start value of a destination address range.
Parameters:
<DestAddrPattMin> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
Parameters for setting and query:
<SearchName> String parameter
Protocols