Rohde & Schwarz RTP Series - Page 1791

Remote control commands
R&S
®
RTP
1791User Manual 1337.9952.02 ─ 12
STARt
Start of frame.
MAC
MAC frame. This frame contains information that define how to
go about transmitting and receiving frames.
IDLE
IDLE frame. This frame is used for clock synchronization.
ERRor
Error frame. You can enable the error to be triggered on:
TRIGger<m>:TBTO:ERRor:CRC
TRIGger<m>:TBTO:ERRor:FEC
TRIGger<m>:TBTO:ERRor:OOR
TRIGger<m>:TBTO:ERRor:ZERO
*RST:
STARt
TRIGger<m>:TBTO:CRC:CONDition
<CRCOperator>
Sets the condition for the frame check. You can define an exact value or a value range.
Suffix:
<m>
.
1..3
Parameters:
<CRCOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding TRIGger<m>:TBTO:CRC:MIN
command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with TRIGger<m>:TBTO:CRC:MIN and
TRIGger<m>:TBTO:CRC:MAX .
*RST:
EQUal
TRIGger<m>:TBTO:CRC:MAX <CRCPatternMax>
Sets the end value of the frame check range if TRIGger<m>:TBTO:CRC:CONDition
is set to INRange or OORange.
Suffix:
<m>
.
1..3
Parameters:
<CRCPatternMax> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (do not care).
Protocols