Rohde & Schwarz RTP Series - Page 1818

Remote control commands
R&S
®
RTP
1818User Manual 1337.9952.02 ─ 12
ERWR
Triggers on Extended Register Write command sequences.
Optionally, you can specify a slave address condition, a register
address condition, a byte count condition, a data index condi-
tion, and a data pattern condition.
ERRD
Triggers on Extended Register Read command sequences.
Optional trigger conditions are the same as for ERWR.
ERWL
Triggers on Extended Register Write Long command sequen-
ces. Optional trigger conditions are the same as for ERWR.
ERRL
Triggers on Extended Register Read Long command sequen-
ces. Optional trigger conditions are the same as for ERWR.
IRSUM
Triggers on Interrupt Summary and Notification command
sequences. Optionally, you can specify a slave address condi-
tion, bit count condition and a data pattern condition.
MSKW
Masked Write command sequence. Optionally, you can specify a
slave address condition, register address condition, mask condi-
tion and data pattern condition
MASOHO
Triggers onMaster Ownership Handover command sequences.
Optionally, you can specify a MID condition.
MASW
Triggers on Master Write command sequences. Optionally, you
can specify a MID condition, a register address condition, and a
data pattern condition.
MASR
Triggers on Master Read command sequences. Optionally, you
can specify a MID condition, a register address condition, and a
data pattern condition.
MCTW
Master Context Transfer Write command sequence. Optional:
MID condition, register address condition, byte count condition,
data index condition, and data pattern condition.
MCTR
Master Context Transfer Read command sequence. Optional
search conditions are the same as for MCTW.
ERRor
Triggers if one of the enabled errors occurs in a frame.
To enable the error types, use TRIGger<m>:RFFE:ERRor:BP,
TRIGger<m>:RFFE:ERRor:LENGth, TRIGger<m>:RFFE:
ERRor:NOResponse, TRIGger<m>:RFFE:ERRor:PARity,
TRIGger<m>:RFFE:ERRor:SSC, and TRIGger<m>:RFFE:
ERRor:USEQuence.
Protocols