Rohde & Schwarz RTP Series - Page 1832

Remote control commands
R&S
®
RTP
1832User Manual 1337.9952.02 ─ 12
<o> *
Selects the number of the data byte (1...n).
Return values:
<ByteState> OK | PARity
OK: the byte is valid.
PARity: parity error
*RST: OK
Usage: Query only
BUS<m>:RFFE:SEQuence<n>:BYTE<o>:VALue?
Returns the value of the specified byte in the specified command sequence.
Suffix:
<m>
.
1..4
<n> *
<o> *
Selects the number of the data byte (1...n).
Return values:
<ByteValue> To set the value format, use FORMat:BPATtern.
The values below – range, increment and reset – are decimal
values.
Range: 0 to 255
Increment: 1
*RST: 0
Usage: Query only
22.17.13.4 Search settings
For programming example, see "Searching RFFE data" on page 1140.
SEARch:TRIGger:RFFE:TYPE......................................................................................1833
SEARch:TRIGger:RFFE:SADD:CONDition..................................................................... 1835
SEARch:TRIGger:RFFE:ADDRess:CONDition................................................................1835
SEARch:TRIGger:RFFE:BCOunt:CONDition...................................................................1835
SEARch:TRIGger:RFFE:DATA:DCON............................................................................1835
SEARch:TRIGger:RFFE:DATA:ICONdition......................................................................1835
SEARch:TRIGger:RFFE:SADD:MIN...............................................................................1836
SEARch:TRIGger:RFFE:ADDRess:MIN......................................................................... 1836
SEARch:TRIGger:RFFE:BCOunt:MIN............................................................................ 1836
SEARch:TRIGger:RFFE:DATA:IMIN...............................................................................1836
SEARch:TRIGger:RFFE:DATA:DMIN............................................................................. 1836
SEARch:TRIGger:RFFE:SADD:MAX..............................................................................1836
SEARch:TRIGger:RFFE:ADDRess:MAX........................................................................ 1836
SEARch:TRIGger:RFFE:BCOunt:MAX...........................................................................1836
SEARch:TRIGger:RFFE:DATA:IMAX............................................................................. 1836
Protocols