Rohde & Schwarz RTP Series - Page 1836

Remote control commands
R&S
®
RTP
1836User Manual 1337.9952.02 ─ 12
EQUal | LTHan | LETHan | GTHan | GETHan
Equal, Less than, Less or equal than, Greater Than, Greater or
equal than. These conditions require one pattern to be set using
SEARch:TRIGger:RFFE:DATA:IMIN.
INRange = RANGe
In range: Set the minimum and maximum value using SEARch:
TRIGger:RFFE:DATA:IMIN and SEARch:TRIGger:RFFE:
DATA:IMAX.
*RST: INRange
Parameters for setting and query:
<SearchName> String parameter
SEARch:TRIGger:RFFE:SADD:MIN
<SearchName>,<SIDMin>
SEARch:TRIGger:RFFE:SADD:MIN? <SearchName>
SEARch:TRIGger:RFFE:ADDRess:MIN <SearchName>,<AddressMin>
SEARch:TRIGger:RFFE:ADDRess:MIN? <SearchName>
SEARch:TRIGger:RFFE:BCOunt:MIN <SearchName>,<ByteCountMin>
SEARch:TRIGger:RFFE:BCOunt:MIN? <SearchName>
SEARch:TRIGger:RFFE:DATA:IMIN <SearchName>,<DataIndexMin>
SEARch:TRIGger:RFFE:DATA:IMIN? <SearchName>
SEARch:TRIGger:RFFE:DATA:DMIN <SearchName>,<DataPatternMin>
SEARch:TRIGger:RFFE:DATA:DMIN? <SearchName>
Specifies a pattern, or sets the the start value of a pattern range.
Parameters:
<DataPatternMin> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
Parameters for setting and query:
<SearchName> String parameter
Example: See "Searching RFFE data" on page 1140
SEARch:TRIGger:RFFE:SADD:MAX <SearchName>,<SIDMax>
SEARch:TRIGger:RFFE:SADD:MAX? <SearchName>
SEARch:TRIGger:RFFE:ADDRess:MAX <SearchName>,<AddressMax>
SEARch:TRIGger:RFFE:ADDRess:MAX? <SearchName>
SEARch:TRIGger:RFFE:BCOunt:MAX <SearchName>,<ByteCountMax>
SEARch:TRIGger:RFFE:BCOunt:MAX? <SearchName>
SEARch:TRIGger:RFFE:DATA:IMAX <SearchName>,<DataIndexMax>
SEARch:TRIGger:RFFE:DATA:IMAX? <SearchName>
SEARch:TRIGger:RFFE:DATA:DMAX <SearchName>,<DataPatternMax>
SEARch:TRIGger:RFFE:DATA:DMAX? <SearchName>
Sets the the end value of an range if the corresponding condition is set to INRange or
OORange. See SEARch:TRIGger:RFFE:...:CON
Protocols