Rohde & Schwarz RTP Series - Page 1837

Remote control commands
R&S
®
RTP
1837User Manual 1337.9952.02 ─ 12
Parameters:
<DataPatternMax> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
Parameters for setting and query:
<SearchName> String parameter
SEARch:TRIGger:RFFE:INTerrupt <SearchName>,<Interrupt>
SEARch:TRIGger:RFFE:INTerrupt? <SearchName>
Defines the pattern of the interrrupt identification sequence, which consists of interrupt
slots 15 to 0.
Parameters:
<Interrupt> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
Parameters for setting and query:
<SearchName> String parameter
Firmware/software: FW 3.30
SEARch:TRIGger:RFFE:ERRor:LENGth <SearchName>,<LengthError>
SEARch:TRIGger:RFFE:ERRor:LENGth? <SearchName>
Enables the search for length errors - when an incorrect length of the command
sequence has been found.
Parameters:
<LengthError> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName> String parameter
SEARch:TRIGger:RFFE:ERRor:PARity <SearchName>,<ParityError>
SEARch:TRIGger:RFFE:ERRor:PARity? <SearchName>
Enables the search for incorrect parity bits.
Parameters:
<ParityError> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName> String parameter
Protocols