Rohde & Schwarz RTP Series - Page 1835

Remote control commands
R&S
®
RTP
1835User Manual 1337.9952.02 ─ 12
Byte count SEARch:TRIGger:RFFE:BCOunt:CONDition
SEARch:TRIGger:RFFE:BCOunt:MIN
SEARch:TRIGger:RFFE:BCOunt:MAX
Data index SEARch:TRIGger:RFFE:DATA:ICONdition
SEARch:TRIGger:RFFE:DATA:IMIN
SEARch:TRIGger:RFFE:DATA:IMAX
SEARch:TRIGger:RFFE:SADD:CONDition <SearchName>,<SIDOperator>
SEARch:TRIGger:RFFE:SADD:CONDition? <SearchName>
SEARch:TRIGger:RFFE:ADDRess:CONDition <SearchName>,<AddressOperator>
SEARch:TRIGger:RFFE:ADDRess:CONDition? <SearchName>
SEARch:TRIGger:RFFE:BCOunt:CONDition <SearchName>,<ByteCntOperator>
SEARch:TRIGger:RFFE:BCOunt:CONDition? <SearchName>
SEARch:TRIGger:RFFE:DATA:DCON <SearchName>,<DatPattOptor>
SEARch:TRIGger:RFFE:DATA:DCON? <SearchName>
Sets the operator to search for a specific pattern or a range
Parameters:
<DatPattOptor> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one pattern to
be set using the corresponding SEARch:TRIG
ger:RFFE:...:MIN command.
INRange | OORange
In range / Out of range: Set the minimum and maximum value
using the corresponding SEARch:TRIGger:RFFE:...:MIN
and SEARch:TRIGger:RFFE:...:MAX
*RST:
EQUal
Parameters for setting and query:
<SearchName> String parameter
Example: See "Searching RFFE data" on page 1140
SEARch:TRIGger:RFFE:DATA:ICONdition <SearchName>,<DataIdxOperator>
SEARch:TRIGger:RFFE:DATA:ICONdition? <SearchName>
Sets the operator to define the data frames in which the data pattern is searched
Parameters:
<DataIdxOperator> EQUal | LTHan | LETHan | GTHan | GETHan | INRange |
RANGe
Protocols