Rohde & Schwarz RTP Series - Page 1913

Remote control commands
R&S
®
RTP
1913User Manual 1337.9952.02 ─ 12
SEARch:TRIGger:MPHY:PFID:CONDition <SearchName>,<CondPACPFunc>
SEARch:TRIGger:MPHY:PFID:CONDition? <SearchName>
Sets the condition for PACP Function ID. You can define an exact value or a value
range.
Parameters:
<CondPACPFunc> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding SEARch:TRIGger:MPHY:
PFID:MIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with SEARch:TRIGger:MPHY:PFID:MIN and
SEARch:TRIGger:MPHY:PFID:MAX.
*RST:
EQUal
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:MPHY:PFID:MIN <SearchName>,<PACPFunIDMin>
SEARch:TRIGger:MPHY:PFID:MIN? <SearchName>
Specifies the PACP Function ID bit pattern, or sets the start value of a pattern range.
Parameters:
<PACPFunIDMin> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:MPHY:PFID:MAX <SearchName>,<PACPFunIDMax>
SEARch:TRIGger:MPHY:PFID:MAX? <SearchName>
Sets the end value of the PACP Function ID range if SEARch:TRIGger:MPHY:PFID:
CONDition is set to INRange or OORange.
Parameters:
<PACPFunIDMax> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
Parameters for setting and query:
<SearchName>
Protocols