Rohde & Schwarz RTP Series - Page 1978

Remote control commands
R&S
®
RTP
1978User Manual 1337.9952.02 ─ 12
BUS<m>:EBTB:SCSY <CustSync2>
Sets the value for the second pattern, if BUS<m>:EBTB:SYNC CUS and
BUS<m>:EBTB:USCS ON.
Suffix:
<m>
.
1..4
Parameters:
<CustSync2>
BUS<m>:EBTB:SYNC
<CommaSymbol>
Sets the sync symbol, a control symbol used for low level control functions.
Suffix:
<m>
.
1..4
Parameters:
<CommaSymbol> K285 | K281 | K287 | CUS
*RST: K285
BUS<m>:EBTB:TYPE <SignalType>
Selects the signal type that is used for the decoding. You can choose between a differ-
ential and single-ended signal.
Suffix:
<m>
.
1..4
Parameters:
<SignalType> DIFFerential | SINGle
*RST: DIFFerential
BUS<m>:EBTB:USCS <IsSecondSync>
Selects whether the second pattern is enabled, if BUS<m>:EBTB:SYNC CUS.
Suffix:
<m>
.
1..4
Parameters:
<IsSecondSync> ON | OFF
*RST: OFF
BUS<m>:EBTB:BITDetermi
Starts a software algorithm for the automatic determination of the bitrate.
Suffix:
<m>
.
1..4
Protocols