Rohde & Schwarz RTP Series - Page 2026

Remote control commands
R&S
®
RTP
2026User Manual 1337.9952.02 ─ 12
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:AMIN <SearchName>,<Address>
SEARch:TRIGger:USB:AMIN? <SearchName>
Specifies an address, or sets the start value of an address range. The string parameter
does not accept the bit value X (don't care).
Parameters:
<Address>
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:AMAX
<SearchName>,<AddressTo>
SEARch:TRIGger:USB:AMAX? <SearchName>
Sets the the end value of an address range if TRIGger<m>:USB:ACONdition is set
to INRange or OORange. The string parameter does not accept the bit value X (don't
care).
Parameters:
<AddressTo>
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:BITSterror <SearchName>,<BitstuffError>
SEARch:TRIGger:USB:BITSterror? <SearchName>
Defines, whether a search for any bitstuffing error shall be activated or not.
Parameters:
<BitstuffError> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:CRC16error <SearchName>,<CRC16Error>
SEARch:TRIGger:USB:CRC16error? <SearchName>
Defines, whether a search for any CRC16 error shall be activated or not.
Parameters:
<CRC16Error> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
Protocols