Rohde & Schwarz RTP Series - Page 2025

Remote control commands
R&S
®
RTP
2025User Manual 1337.9952.02 ─ 12
SEARch:TRIGger:USB:HAND.......................................................................................2030
SEARch:TRIGger:USB:PATT........................................................................................ 2030
SEARch:TRIGger:USB:PCONdition............................................................................... 2031
SEARch:TRIGger:USB:PMIN........................................................................................ 2031
SEARch:TRIGger:USB:PMAX.......................................................................................2031
SEARch:TRIGger:USB:PIDerror....................................................................................2031
SEARch:TRIGger:USB:SCONdition............................................................................... 2032
SEARch:TRIGger:USB:SMIN........................................................................................ 2032
SEARch:TRIGger:USB:SMAX.......................................................................................2032
SEARch:TRIGger:USB:SDATa...................................................................................... 2033
SEARch:TRIGger:USB:SERRor.................................................................................... 2033
SEARch:TRIGger:USB:SHANdshake.............................................................................2033
SEARch:TRIGger:USB:SSOP....................................................................................... 2033
SEARch:TRIGger:USB:SSPE........................................................................................2034
SEARch:TRIGger:USB:SPEC....................................................................................... 2034
SEARch:TRIGger:USB:STCO....................................................................................... 2034
SEARch:TRIGger:USB:STOKen....................................................................................2035
SEARch:TRIGger:USB:TCONdition............................................................................... 2035
SEARch:TRIGger:USB:TMIN........................................................................................ 2035
SEARch:TRIGger:USB:TMAX....................................................................................... 2036
SEARch:TRIGger:USB:TOKen......................................................................................2036
SEARch:TRIGger:USB:WADD...................................................................................... 2036
SEARch:TRIGger:USB:WEND...................................................................................... 2037
SEARch:TRIGger:USB:WETCheck................................................................................2037
SEARch:TRIGger:USB:WFRN.......................................................................................2037
SEARch:TRIGger:USB:WPAY....................................................................................... 2037
SEARch:TRIGger:USB:WPID........................................................................................2038
SEARch:TRIGger:USB:WPOR...................................................................................... 2038
SEARch:TRIGger:USB:WSEU.......................................................................................2038
SEARch:TRIGger:USB:WSTC.......................................................................................2038
SEARch:TRIGger:USB:ACONdition <SearchName>,<OperatorAddress>
SEARch:TRIGger:USB:ACONdition? <SearchName>
Sets the operator to set a specific address or an address range.
Parameters:
<OperatorAddress> OFF | ANY | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less than or equal, Greater than,
Greater than or equal. These conditions require one address
value to be set using SEARch:TRIGger:USB:AMIN.
INRange | OORange
In range, out of range. These conditions require an address
range to be set using SEARch:TRIGger:USB:AMIN and
SEARch:TRIGger:USB:AMAX.
*RST: OFF
Protocols