Rohde & Schwarz RTP Series - Page 2193

Remote control commands
R&S
®
RTP
2193User Manual 1337.9952.02 ─ 12
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
EYE<m>:FILTer:BPATtern:MODE <Mode>
Selects which bits contribute to the eye generation.
Suffix:
<m>
.
1..4
Parameters:
<Mode> ABITs | LTRansition | CLEVel | BPATtern
ABITs
All bits contribute to the eye diagram, same as EYE<m>:
FILTer:STATe is OFF.
LTRansition
Level transition, only bits after a signal transition contribute (0 to
1, or 1 to 0).
CLEVel
Constant level, only bits without a preceding signal transition
contribute ( 0 to 0, or 1 to 1).
BPATtern
Only bits contribute that match the defined pattern before and
after the center eye.
*RST:
ABITs
Usage: Asynchronous command
EYE<m>:FILTer:BPATtern:PREFix<1..8> <Bit>
EYE<m>:FILTer:BPATtern:CENTer <BitValue>
EYE<m>:FILTer:BPATtern:SUFFix<1..5> <Bit>
Set the values of the indicated prefix, center, and suffix bits.
Suffix:
<m>
.
1..4
Parameters:
<Bit> ONE | ZERO | DC
DC: don't care
EYE<m>:FILTer:BPATtern:SLEFt
Shifts the pattern one bit to the left.
Suffix:
<m>
.
1..4
Protocols