Rohde & Schwarz RTP Series - Page 2230

Remote control commands
R&S
®
RTP
2230User Manual 1337.9952.02 ─ 12
WGENerator<m>:ARBGen:NAME................................................................................. 2231
WGENerator<m>:ARBGen:OPEN................................................................................. 2231
WGENerator<m>:ARBGen:RUNMode............................................................................2231
WGENerator<m>:ARBGen:SAMPles?............................................................................2232
WGENerator<m>:ARBGen:SELect................................................................................ 2232
WGENerator<m>:ARBGen:SRATe.................................................................................2232
WGENerator<m>:ARBGen[:SOURce]............................................................................ 2232
WGENerator<m>:ARBGen:RUNSingle...........................................................................2233
WGENerator<m>:ARBGen:COPY
Loads the waveform from the selected signal source (WGENerator<m>:ARBGen:
SELect).
Suffix:
<m>
.
1..2
Usage: Event
Asynchronous command
WGENerator<m>:ARBGen:MULTichannel:IMPort <SavedWfmSrc>
Assigns a waveform from the multichannel file to the arbitrary waveform generator.
Suffix:
<m>
.
1..2
Parameters:
<SavedWfmSrc> WFM1 | WFM2 | WFM3 | WFM4
*RST: WFM1
Example:
WGENerator1:ARBGen:MULTichannel:NAME
ArbMultichannelCurve_2017-02-16_01.bin
WGENerator1:ARBGen:MULTichannel:IMPort WF1
WGENerator1:ARBGen:MULTichannel:OPEN
WGENerator<m>:ARBGen:MULTichannel:NAME <FilePath>
Defines the path and the multichannel arbitrary waveform file to be imported. If not
path is given, the default path
C:\Users\Public\Public Documents\Rohde-Schwarz\RTx\RefWaveforms
is used.
Suffix:
<m>
.
1..2
Parameters:
<FilePath>
Example: See WGENerator<m>:ARBGen:MULTichannel:IMPort
on page 2230.
Waveform generator (option R&S RTP-B6)