Rohde & Schwarz RTP Series - Page 2266

Remote control commands
R&S
®
RTP
2266User Manual 1337.9952.02 ─ 12
ADVJitter<m>:SIGNal:GATE:RANGe:ABSolute:STARt <StartValue>
Sets the start time of the gate area in percent, if ADVJitter<m>:SIGNal:GATE:
RANGe:MODE is set to ABS.
Suffix:
<m>
.
1..2
Parameters:
<StartValue> Range: -100E+24 to 100E+24
Increment: 0.01
*RST: 0
ADVJitter<m>:SIGNal:GATE:RANGe:ABSolute:STOP
<StopValue>
Sets the stop time of the gate area in percent, if ADVJitter<m>:SIGNal:GATE:
RANGe:MODE is set to ABS.
Suffix:
<m>
.
1..2
Parameters:
<StopValue> Range: -100E+24 to 100E+24
Increment: 0.01
*RST: 0.01
ADVJitter<m>:SIGNal:GATE:RANGe:MODE <ModeType>
Selects if the gate area is defined in relative values (percent) or absolute.
Suffix:
<m>
.
1..2
Parameters:
<ModeType> ABS | REL
*RST: ABS
ADVJitter<m>:SIGNal:GATE:RANGe:RELative:STARt <StartValue>
Sets the relative start of the gate area in percent, if ADVJitter<m>:SIGNal:GATE:
RANGe:MODE is set to REL.
Suffix:
<m>
.
1..2
Parameters:
<StartValue> Range: 0 to 100
Increment: 0.1
*RST: 0
Default unit: %
Jitter analysis and clock data recovery