Rohde & Schwarz RTP Series - Page 2277

Remote control commands
R&S
®
RTP
2277User Manual 1337.9952.02 ─ 12
Bathtub
ADVJitter<m>:DCOMposition:TARBer............................................................................2277
ADVJitter<m>:RESult:BATHtub..................................................................................... 2277
ADVJitter<m>:RESult:TYPBathtub.................................................................................2277
ADVJitter<m>:RESult:PJ.............................................................................................. 2277
ADVJitter<m>:RESult:OBUJ..........................................................................................2278
ADVJitter<m>:RESult:NBAThtub....................................................................................2278
ADVJitter<m>:RESult:PN..............................................................................................2278
ADVJitter<m>:RESult:OBUN.........................................................................................2278
ADVJitter<m>:DCOMposition:TARBer <TargetBtErrRate>
Sets the target bit error rate for total jitter at BER components.
Suffix:
<m>
.
1..2
Parameters:
<TargetBtErrRate> Range: 1 to 32
Increment: 1
*RST: 12
ADVJitter<m>:RESult:BATHtub <State>
Enables a bathtub plot for the advanced jitter measurements.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: OFF
ADVJitter<m>:RESult:TYPBathtub <BathtubType>
Selects if you want to display the bathtub results versus total jitter (TJ) or data-depend-
ent jitter (DDJ) and random jitter (RJ) components.
Suffix:
<m>
.
1..2
Parameters:
<BathtubType> DDJ | DDJP | DDJB | DDJO | TJ | DDJRj
TJ: Total jitter
DDJRJ: Data-dependent jitter and random jitter.
*RST: TJ
ADVJitter<m>:RESult:PJ <State>
If enabled, the periodic jitter components are considered for the jitter bathtub.
Jitter analysis and clock data recovery