Rohde & Schwarz RTP Series - Page 2279

Remote control commands
R&S
®
RTP
2279User Manual 1337.9952.02 ─ 12
Parameters:
<State> ON | OFF
*RST: ON
Eye
ADVJitter<m>:RESult:PHORizontal............................................................................... 2279
ADVJitter<m>:RESult:PVERtical....................................................................................2279
ADVJitter<m>:RESult:SYNTheticeye..............................................................................2279
ADVJitter<m>:RESult:TYPSynteye................................................................................ 2279
ADVJitter<m>:RESult:PHORizontal <State>
If enabled, adds horizontal periodic components to the data-dependent synthetic eye.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: OFF
ADVJitter<m>:RESult:PVERtical <State>
If enabled, adds vertical periodic components to the data-dependent synthetic eye.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: OFF
ADVJitter<m>:RESult:SYNTheticeye <State>
Selects if you want to display synthetic eye results only for the deterministic jitter (DJ)
components or the data-dependent jitter (DDJ) components.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: OFF
ADVJitter<m>:RESult:TYPSynteye <SyntheticEyeTyp>
Selects if you want to display synthetic eye results only for the deterministic jitter (DDP)
components or the data-dependent jitter (DD) components.
Jitter analysis and clock data recovery