Rohde & Schwarz RTP Series - Page 2280

Remote control commands
R&S
®
RTP
2280User Manual 1337.9952.02 ─ 12
Suffix:
<m>
.
1..2
Parameters:
<SyntheticEyeTyp> DD | DDPH | DDPV | DDP
*RST: DDP
Diagram
ADVJitter<m>:RESult:VERTical:HBINs...........................................................................2280
ADVJitter<m>:RESult:VERTical:CONTinuous................................................................. 2280
ADVJitter<m>:RESult:VERTical:BMTYpe........................................................................2281
ADVJitter<m>:RESult:VERTical:BHContinuous............................................................... 2281
ADVJitter<m>:RESult:VERTical:JSContinuous................................................................2281
ADVJitter<m>:RESult:VERTical:NHContinuous...............................................................2281
ADVJitter<m>:RESult:VERTical:NSContinuous............................................................... 2282
ADVJitter<m>:RESult:COMPonents<n>:SCALe..............................................................2282
ADVJitter<m>:RESult:COMPonents<n>:OFFSet.............................................................2282
ADVJitter<m>:DCOMposition:SPJTable..........................................................................2283
ADVJitter<m>:DCOMposition:SPJLabels........................................................................2283
ADVJitter<m>:DCOMposition:SPNLabels.......................................................................2283
ADVJitter<m>:DCOMposition:JINTerleaved.................................................................... 2284
ADVJitter<m>:RESult:VERTical:HBINs <MaxBinNumber>
Sets the number of bins, the number of data intervals, of the histogram.
Suffix:
<m>
.
1..2
Parameters:
<MaxBinNumber> Range: 2 to 1000
Increment: 10
*RST: 200
ADVJitter<m>:RESult:VERTical:CONTinuous <State>
If enabled, the measurement scale is set automatically.
If disabled you can manually set a ADVJitter<m>:RESult:COMPonents<n>:
SCALe and a ADVJitter<m>:RESult:COMPonents<n>:OFFSet.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: ON
Jitter analysis and clock data recovery