Measurements
R&S
®
RTP
372User Manual 1337.9952.02 ─ 12
Remote command:
MEASurement<m>:SPECtrum:CPOWer:CFRequency on page 1393
Occup. BW
Percentage of the total power used to determine the occupied bandwidth.
Remote command:
MEASurement<m>:SPECtrum:OBANdwidth on page 1393
Threshold
Defines an absolute threshold as an additional condition for the peak search. Only
peaks that exceed the threshold are detected.
This setting is only available for spectrum waveforms. It is valid for cursor measure-
ments, spectrum measurements and peak search.
Remote command:
CURSor<m>:THReshold on page 1508
MEASurement<m>:SPECtrum:ATHReshold on page 1394
Peak excursion
Defines a relative threshold, the minimum level value by which the waveform must rise
or fall to be considered as a peak. To avoid identifying noise peaks, enter a peak
excursion value that is higher than the noise levels.
This setting is only available for spectrum waveforms. It is valid for cursor measure-
ments, spectrum measurements and peak search.
The following figure shows a cursor measurement on a spectrum waveform:
Automatic measurements
To Next Page
Loading...
