Rohde & Schwarz RTP Series - Page 398

Measurements
R&S
®
RTP
398User Manual 1337.9952.02 ─ 12
Limits are stricter than the margins for the value check. Thus, the margins must be
within the valid range. If necessary, the limit and margin values are adapted according
to the selected valid range.
The settings are only visible if "Limit check" is enabled.
Remote command:
MEASurement<m>:AMPTime:LCHeck<n>:LOWer:LIMit on page 1379
MEASurement<m>:AMPTime:LCHeck<n>:LOWer:MARGin on page 1380
MEASurement<m>:AMPTime:LCHeck<n>:UPPer:LIMit on page 1379
MEASurement<m>:AMPTime:LCHeck<n>:UPPer:MARGin on page 1380
MEASurement<m>:AMPTime:LCHeck<n>:VALid on page 1379
To check limits and margins of jitter measurements, use the AMPTime remote com-
mands.
MEASurement<m>:EYEJitter:LCHeck<n>:LOWer:LIMit on page 1390
MEASurement<m>:EYEJitter:LCHeck<n>:LOWer:MARGin on page 1391
MEASurement<m>:EYEJitter:LCHeck<n>:UPPer:LIMit on page 1390
MEASurement<m>:EYEJitter:LCHeck<n>:UPPer:MARGin on page 1391
MEASurement<m>:EYEJitter:LCHeck<n>:VALid on page 1390
MEASurement<m>:HISTogram:LCHeck<n>:LOWer:LIMit on page 1407
MEASurement<m>:HISTogram:LCHeck<n>:LOWer:MARGin on page 1408
MEASurement<m>:HISTogram:LCHeck<n>:UPPer:LIMit on page 1407
MEASurement<m>:HISTogram:LCHeck<n>:UPPer:MARGin on page 1408
MEASurement<m>:HISTogram:LCHeck<n>:VALid on page 1407
MEASurement<m>:SPECtrum:LCHeck<n>:LOWer:LIMit on page 1397
MEASurement<m>:SPECtrum:LCHeck<n>:LOWer:MARGin on page 1398
MEASurement<m>:SPECtrum:LCHeck<n>:UPPer:LIMit on page 1397
MEASurement<m>:SPECtrum:LCHeck<n>:UPPer:MARGin on page 1398
MEASurement<m>:SPECtrum:LCHeck<n>:VALid on page 1397
8.2.12.3 Actions on limit check results
To define what happens when the limits and margins are exceeded, tap Action on limit
event below the limit and margin ranges.
Actions are initiated by all measurements and all results measured on one acquisition.
Automatic measurements