Rohde & Schwarz RTP Series - Page 605

Protocol analysis
R&S
®
RTP
605User Manual 1337.9952.02 ─ 12
"Status Word"
Triggers on a specified status word.
"Error Condi-
tion"
Triggers on any combination of protocol errors.
Remote command:
TRIGger<m>:MILStd:TYPE on page 1689
Sync Type / Word Type
Triggers on a sync impulse or word type. You can select to trigger on "Command/
Status", on "All" or on "Data" sync pulses / word types.
Remote command:
TRIGger<m>:MILStd:TPSPecifier on page 1697
Remote Terminal Address
The RTA setup consists of the condition and one or two RTA patterns.
In binary format, use the following characters: 1; 0; or X (do not care). To enter the pat-
tern in other formats use the bit pattern editor, see Chapter 13.1.7, "Bit pattern editor",
on page 519.
MIL-1553 (option R&S
RTP-K6)