Rohde & Schwarz RTP Series - Page 675

Protocol analysis
R&S
®
RTP
675User Manual 1337.9952.02 ─ 12
"Condition"
Defines the operator to set a specific frame check, e.g. "Equal" or
"Not Equal") or a range.
"Data Min/Data"
Defines the bit pattern of the frame check pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor", on page 519.
"Data Max"
The second data pattern is required to specify a range with conditions
"In range" and "Out of range".
Remote command:
SEARch:TRIGger:TBTO:CRC:CONDition on page 1798
SEARch:TRIGger:TBTO:CRC:MIN on page 1799
SEARch:TRIGger:TBTO:CRC:MAX on page 1798
Data
Sets the specified data to be searched for. The data setup consists of the condition and
one or two data patterns.
"Condition"
Defines the operator to set a specific data, e.g. "Equal" or "Not
Equal") or a range.
"Data Min/Data"
Defines the bit pattern of the data pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor", on page 519.
"Data Max"
The second data pattern is required to specify a range with conditions
"In range" and "Out of range".
Remote command:
SEARch:TRIGger:TBTO:DATA:DCONdition on page 1800
SEARch:TRIGger:TBTO:DATA:DMIN on page 1801
SEARch:TRIGger:TBTO:DATA:DMAX on page 1800
Index
Sets the specified value or range within this series of data that is considered for the
search. The index setup consists of the condition and one or two index values.
"Condition"
Defines the operator to set a specific index, e.g. "Equal" or a range.
"Index Min/Index"
Defines the bit pattern of the index pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor", on page 519.
"Index Max"
The second index pattern is required to specify a range with condi-
tions "In range".
Ethernet 1000BASE-T1 (option R&S RTP-K58)