Rohde & Schwarz RTP Series - Page 691

Protocol analysis
R&S
®
RTP
691User Manual 1337.9952.02 ─ 12
To trigger on any data byte that fulfills the data pattern settings, set the index to XX.
"Condition"
Sets the operator to trigger on a specific data frame ("Equal") or a
data frame range.
"Data (Min)"
Defines the frame index of the data pattern for all operators that
require one index.
"Data (Max)"
Defines the frame index of the last data pattern that is required to
specify a range with condition "In range". The instrument adjusts this
value, if you enter a data pattern that is longer than the index range.
Remote command:
TRIGger<m>:RFFE:DATA:ICONdition on page 1822
TRIGger<m>:RFFE:DATA:IMIN on page 1822
TRIGger<m>:RFFE:DATA:IMAX on page 1822
Mask
Defines the mask trigger condition. The mask setup consists of the condition and one
or two data patterns.The setting is available for "Masked Write" command sequences.
"Condition"
Sets the operator to trigger on a specific mask frame ("Equal") or a
mask frame range.
"Mask (Min)"
Defines the mask pattern for all operators that require one pattern.
"Mask (Max)"
Defines the second mask pattern that is required to specify a range
with conditions "In range" and "Out of range".
Remote command:
TRIGger<m>:RFFE:MASK:CONDition on page 1823
TRIGger<m>:RFFE:MASK:MIN on page 1824
TRIGger<m>:RFFE:MASK:MAX on page 1823
13.12.3.2 Triggering on RFFE signals
Prerequisites: An RFFE bus is configured, see Chapter 13.12.2, "RFFE configuration",
on page 680, and "Decode" is enabled.
1. Press the [Protocol] key and selet the "Shortcuts" tab.
2. Press "Setup trigger".
3. Tap the "Source" button and select the "Serial bus" trigger source.
4. Tap "Serial bus" and select the serial bus that is set to RFFE.
5. Select the "Trigger type".
6. To refine the trigger settings, configure additional settings, which are available for
many trigger types.
For details, see Chapter 13.12.3.1, "RFFE trigger settings", on page 684.
RFFE (option R&S
RTP-K40)