Protocol analysis
R&S
®
RTP
711User Manual 1337.9952.02 ─ 12
13.13.5.1 D-PHY search setup
Access: [Protocol] > "Shortcuts" tab > "Setup search"
Type
Searches for the selected D-PHY type.
Remote command:
SEARch:TRIGger:DPHY:TYPE on page 1861
HS Start of Packet ← Type
Searches for a transmission start of a high-speed packet.
HS End of Packet ← Type
Searches for a transmission end of a high-speed packet.
HS Packet Header ← Type
Searches for a packet header of a high-speed package. The header consists of a data
identifier (containing the Virtual Channel and the Data Type) and a Word Count/ Data.
You can specify the values each part of the packet header.
HS Data ← Type
Searches for a specified high-speed data.
LP Escape Mode ← Type
Searches for an escape mode event.
LP Lane Turnaround ← Type
Searches for a low-power turnaround, a reversion of the transmission direction.
LP HS Request ← Type
Searches for a high-speed request.
Virtual Channel
Searches for a specific virtual channel, an independent data stream for up to four
peripherals.
Remote command:
SEARch:TRIGger:DPHY:HSVC on page 1868
D-PHY (ption R&S
RTP-K42)
To Next Page
Loading...
