Rohde & Schwarz RTP Series - Page 712

Protocol analysis
R&S
®
RTP
712User Manual 1337.9952.02 ─ 12
Data Type
Searches for a specific data type. The data type setup consists of the condition and
one or two data patterns.
"Condition"
Defines the operator to set a specific data type ("Equal" or "Not
equal") or a data type range.
"Data Min/Data"
Defines the bit pattern of the data pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor", on page 519.
"Data Max"
The second data pattern is required to specify a range with conditions
"In range" and "Out of range".
Remote command:
SEARch:TRIGger:DPHY:DTYPe:CONDition on page 1864
SEARch:TRIGger:DPHY:DTYPe:MAX on page 1864
SEARch:TRIGger:DPHY:DTYPe:MIN on page 1864
Word Count/ Data
Searches for a specific word count /data. The word count setup consists of the condi-
tion and one or two data patterns.
"Condition"
Defines the operator to set a specific word count ("Equal" or "Not
equal") or a word count range.
"Data Min/Data"
Defines the bit pattern of the word pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor", on page 519.
"Data Max"
The second word pattern is required to specify a range with condi-
tions "In range" and "Out of range".
Remote command:
SEARch:TRIGger:DPHY:WCOunt:CONDition on page 1868
SEARch:TRIGger:DPHY:WCOunt:MAX on page 1868
SEARch:TRIGger:DPHY:WCOunt:MIN on page 1869
Data Value
Searches for a specific data value. The data value setup consists of the condition and
one or two data value patterns.
"Condition"
Defines the operator to set a specific data value ("Equal" or "Not
equal") or a data value range.
"Data Min/Data"
Defines the bit pattern of the data value pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor", on page 519.
D-PHY (ption R&S RTP-K42)