Rohde & Schwarz RTP Series - Page 729

Protocol analysis
R&S
®
RTP
729User Manual 1337.9952.02 ─ 12
"Data Min/Data"
Defines the bit pattern of the credit pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor", on page 519.
"Data Max"
The second credit pattern is required to specify a range with condi-
tions "In range" and "Out of range".
Remote command:
TRIGger<m>:MPHY:CREDit:CONDition on page 1888
TRIGger<m>:MPHY:CREDit:MIN on page 1889
TRIGger<m>:MPHY:CREDit:MAX on page 1889
PACP Begin
Sets the specified PACP Begin to be triggered on. The PACP Begin setup consists of
the condition and one or two PACP Begin patterns.
"Condition"
Defines the operator to set a specific PACP Begin, e.g. "Equal" or
"Not Equal" or a range.
"Data Min/Data"
Defines the bit pattern of the data value pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor", on page 519.
"Data Max"
The second PACP Begin pattern is required to specify a range with
conditions "In range" and "Out of range".
Remote command:
TRIGger<m>:MPHY:PBEGin:CONDition on page 1889
TRIGger<m>:MPHY:PBEGin:MIN on page 1889
TRIGger<m>:MPHY:PBEGin:MAX on page 1890
PACP Function ID
Sets the specified PACP Function ID to be triggered on. The PACP Function ID setup
consists of the condition and one or two PACP Function ID patterns.
"Condition"
Defines the operator to set a specific PACP Function ID, e.g. "Equal"
or "Not Equal" or a range.
"Data Min/Data"
Defines the bit pattern of the PACP Function ID pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor", on page 519.
"Data Max"
The second PACP Function ID pattern is required to specify a range
with conditions "In range" and "Out of range".
Remote command:
TRIGger<m>:MPHY:PFID:CONDition on page 1890
TRIGger<m>:MPHY:PFID:MIN on page 1890
TRIGger<m>:MPHY:PFID:MAX on page 1891
M-PHY and USB SSIC (option R&S
RTP-K44 and K64)