Scanlab RTC6 PCIe Board - Page 1001

RTC6 boards
Doc. Rev. 1.0.21 en-US
21 Appendix F: Change Index
1001
innovators for industry
Changes to Document Revision 1.0.20 en-US from Document Revision 1.0.19 en-US
Where What
Global Document Revision
• 1.0.20 en-US
applies to RTC6 Software Package
• V1.14.1
(a)
Chapter 1 ”About this Manual”, page 24 Editorial change.
Section ”Folder RTC6 Tools”, page 34 Software change.
(a)
BIOS-ETH 35.
Chapter 4.4 ”Master Socket Connector,
Slave Socket Connector”, page 66
Hardware change. #149963 (previously: #117241).
eth_set_high_performance_mode,
page 379
Software change.
(a)
New command.
get_error, page 398 Software change.
(a)
Error bit Bit #17 no longer “reserved”,
see page 400.
get_list_pointer, page 413 Editorial enhancement. New comment, page 413.
set_laser_control, page 668 Editorial enhancement. Further clarification with Bit #3 and
Bit #4.
set_mcbsp_out_oie_ctrl, page 696 Software change.
(a)
New command.
set_mcbsp_out_oie_list, page 696 Software change.
(a)
New command.
set_vector_control, page 762 Software change. Ctrl = 8.
wait_for_encoder_mode, page 845 Editorial change. wait_for_encoder_mode is category
“Normal List Command”
(not: “Multiple List Command”).
w
rite_port_list, page 862 Software change.
(a)
New command.
Chapter 16.7.1 ”Upgrading BIOS-ETH”,
page 909
Software change.
(a)
BIOS-ETH 35.
Chapter 16.8 ”“High Performance Mode””,
page 916
Software change.
(a)
New functionality for RTC6 Ethernet
Boards: “High Performance Mode”.