Scanlab RTC6 PCIe Board - Page 1000

RTC6 boards
Doc. Rev. 1.0.21 en-US
21 Appendix F: Change Index
1000
innovators for industry
Changes to Document Revision 1.0.19 en-US from Document Revision 1.0.18 en-US
Where What
Global Document Revision
• 1.0.19 en-US
applies to RTC6 Software Package
• V1.13.0
(a)
Chapter 1 ”About this Manual”, page 24 Editorial change.
Section ”Folder RTC6 Tools”, page 34 Software change.
(a)
BIOS-ETH 33.
Chapter 7.3.4 ”3D Image Field”, page 171 Editorial enhancement. ABC values from the *_ReadMe.txt file
of correction file are to be interpreted as 16-bit values.
load_z_table_20b, page 519 Editorial change. Allowed value range for A , B , C .
load_z_table_no_20b, page 521 Editorial change. Allowed value range for A , B , C .
set_mcbsp_out_ptr, page 697 Software change.
(a)
Number Bit 31.
set_mcbsp_out_ptr_list, page 698 Software change.
(a)
New command.
set_wobbel_vector, page 776 Software change.
(a)
Calculation for the variation of the
current laser power P after set_wobbel_mode ( Mode = 2 ):
formula, page 777
(instead of: P = P0 × (1 + dPower × n).
set_wobbel_vector, page 776 Software change.
(a)
Calculation for the variation of the
current laser power P after set_wobbel_mode ( Mode = 3 ):
formula, page 778
(instead of: P = P100 × (factor + dPower × n)).
Chapter 16.7.1 ”Upgrading BIOS-ETH”,
page 909
Software change.
(a)
BIOS-ETH 33.
Chapter 19 ”Appendix D: RTC6 Software
Packages – History”, page 939
Software change.
(a)
V1.13.0.
Appendix F: Change Index, page 984
(a) See also RTC6_Software_RevisionHistory_<Date>_<Rev>.pdf .