Scanlab RTC6 PCIe Board - Page 999

RTC6 boards
Doc. Rev. 1.0.21 en-US
21 Appendix F: Change Index
999
innovators for industry
Changes to Document Revision 1.0.18 en-US from Document Revision 1.0.17 en-US
Where What
Global Document Revision
• 1.0.18 en-US
applies to RTC6 Software Package
• V1.12.0
(a)
Chapter 1 ”About this Manual”, page 24 Editorial change.
Section ”Folder RTC6 Tools”, page 34 Software change.
(a)
BIOS-ETH 33.
Section ”Checking the z axis Calibration”,
page 170
Editorial enhancement. Notes, page 171 and
RTC6 commands from V1.12.0.
get_temperature, page 434 Software change.
(a)
New command.
load_z_table_20b, page 519 Software change.
(a)
New command.
load_z_table_no_20b, page 521 Software change.
(a)
New command.
read_abc_from_file_20b, page 578 Software change.
(a)
New command.
set_wobbel_control, page 768 Software change.
(a)
With Ctrl = 8, now alternation occurs
with every Microstep (no longer with every
set_wobbel_vector call.
set_wobbel_vector_2, page 780 Software change.
(a)
New command.
write_abc_to_file_20b, page 853 Software change.
(a)
New command.
Chapter 16.7.1 ”Upgrading BIOS-ETH”,
page 909
Software change.
(a)
BIOS-ETH 33.
Chapter 19 ”Appendix D: RTC6 Software
Packages – History”, page 939
Software change.
(a)
V1.12.0.
Appendix F: Change Index, page 984
(a) See also RTC6_Software_RevisionHistory_<Date>_<Rev>.pdf .