Scanlab RTC6 PCIe Board - Page 926

RTC6 boards
Doc. Rev. 1.0.21 en-US
16 Appendix A: The RTC6 Ethernet Board
926
innovators for industry
LASER Socket Connector (cont’d)
Input ports for external
start and stop signals
TTL active-LOW, internally
connected to +3.3 V by
pull-up resistors (4.7 k)
• /START Edge sensitive
• /STOP Level sensitive
• Reference GND
Other signals
• BUSY OUT 5 V, TTL active-HIGH,
Max. 10 mA,
Reference GND
• +5 V Max. 100 mA
• Reference GND
EXTENSION 1 Socket Connector
Connector 40 pin socket connector
with 2.00 mm pitch of the
pins
(a)
.
Output signal level is
configurable by solder
jumper field A
(a) With RTC6 PCIe Boards: 2.54 mm pitch of the pins.
Digital output port 16 Bits, buffered
• LOW level < 0.4 V
• HIGH level > 2.0 V (3.3 V or 5 V)
• Max. current load ±8 mA
• Reference GND
• LATCH-Signal 3.3 V or 5 V,
TTL active-HIGH,
5 µs pulse, max. 10 mA
Digital input port 16 Bit, protected
• LOW level < 0.5 V
• HIGH level > 2.6 V…24 V
• Max. input voltage
range
–0.5 V…+26 V
• Input resistance > 10 k
• Reference GND
• SYNC-Signal 3.3 V or 5 V, TTL
active-HIGH, square wave
signal (5 µs pulse, 10 µs
period), max. 10 mA
Other signals
• BUSY OUT 3.3 V or 5 V,
TTL active-HIGH,
max. 10 mA
• VCC 3.3 V or 5 V,
max. 100 mA
• +5 V Max. 100 mA
• Reference GND