Scanlab RTC6 PCIe Board - Page 925

RTC6 boards
Doc. Rev. 1.0.21 en-US
16 Appendix A: The RTC6 Ethernet Board
925
innovators for industry
Interfaces to Scan Systems
SCANHEADs Socket Connector
Connector 20 pin socket connector
with 2.54 mm pitch of the
pins
(a)
.
The signals for the first
scan head are outputted at
pin (01)…pin (10).
The signals for the second
scan head are outputted at
pin (11)…pin (20):
• xy output values only
with enabled Option
“Second Scan Head
Control”
• z output values only
with enabled Option
“3D”
(a) Not as with RTC6 PCIe Board.
Signal transmission SL2-100 protocol.
Via XY2-100 Converter
(Accessory):
XY2-100 protocol
LASER Socket Connector
Connector 16 pin socket connector
with 2.54 mm pitch of the
pins
(a)
(a) Not as with RTC6 PCIe Board.
Laser Control Signals LASER1, LASER2, LASERON
• TTL level 5 V, active-HIGH or
active-LOW programmable
• Max. current load 20 mA
• Reference GND - boards without
Option “DC/DC Converter”.
GND2 - boards with
Option “DC/DC Converter”
Analog output ports ANALOG OUT1,
ANALOG OUT2
(b)
(b) With RTC5 boards and RTC6 PCIe Boards, the
ANALOG OUT2 signal is also available at the
MARKING ON THE FLY socket connector.
• Output voltage
range
0 V…10 V
• Resolution 12 Bit
• Max. current load 5 mA
• Reference GND
Digital input ports 2 Bits
• LOW level < 0.6 V
• HIGH level > 2.3 V
• Max. input voltage
range
–0.5 V…+5.5 V
• Input resistance
(pull-up)
> 4.7 k
• Reference GND
Digital output port 2 Bits, buffered
• LOW level < 0.55 V
• HIGH level > 3.8 V
• Max. current load 20 mA
• Reference GND